• Realistic look & feel satisfies even the most demanding gentleman
• Powerful 10-speed bullet inside adds toe-curling vibrations to drain you dry
• Textured interior delivers massaging stimulation from top to bottom
• Closed end design creates delicious sucking sensation for your tool
• Easy single button controller on the unit
• Stroker is made from soft & flexible TPE with an ABS plastic case
• Case is 7.25 inches tall, 3 inches wide
• TPE stroker inside is 5 inches deep, 1.75 inches wide overall
• Case closes with a cap for easy, discreet storage and charging
• USB rechargeable, 3 hour charge, up to 90 minutes play, cable included
• Use with water base lubes only
• Stroker sleeve is removable for easy cleaning

Who doesn't love a nice, tight stroker with stimulating bumps & ridges inside? Add a 10-speed vibrating bullet inside and the fun really begins! The vibe sends delicious vibrations surging through every inch of the masturbator to stimulate you all over. And the interior comes lined with ticklers & teasers for even more stimulation with every stroke! And the closed end of the TPE stroker creates a powerful suction force your tool will love.

This vibrating male masturbator's ABS plastic case measures 3 inches wide by 7.25 inches long overall. Inside, a generously sized stroker takes in almost 5 inches with a nice, tight feel. It’s made from soft and flexible TPE, giving the stroker a life-like look and feel similar to the real deal.

Your Vibro Pleasure Dome is rechargeable with the USB cable provided. It connects via a pin at the top of the unit. A 3 hour charge should give you up to 90 minutes of play, depending on what speeds you use (if you can last that long!). 

Use & Cleaning

The Vibro Pleasure Dome is compatible with water-based sex lubes. To clean the stroker, uncap the unit and slowly, carefully pull out the TPE sleeve from its hard plastic case. You'll see a wire attached to the vibrating egg that resides in a pocket inside the TPE sleeve –– slowly slide the bullet out of the sleeve without disconnecting the wire. Then flush out the TPE sleeve with warm water & mild soap. Make sure it is completely dry inside before placing it back into its case.